What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 00:52

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
What does a fuse do?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
NASA is already great. Right now. - NASA Watch
[old diagram got deleted by accident]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
He then asserts :
The third is lightning and “how it gets conducted into a home.”
Upvotes:
In schematic diagrams this is the symbol for a fuse:
What are my 10 favorite rock record album opening tracks?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The other is “what does a “fuse” do?”
Why does a lot of the YouTube community support the MGTOW movement?
These devices are installed between the “hot” and “neutral” and protective ground.
[image of Common-mode choke]
A fuse is a non-resetable over current circuit protector.
TSMC Sees Limited Tariff Impact on AI Strength - WSJ
a photo is worth a thousand words.
This one hit behind the barn.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At least they know the answer if they wanted it.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Why is Russia always right? All eyes toward Russian glory!
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
what exactly is a ‘surge’ protector?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
the problem then depends on "how fast does the fuse operate?".
This is 'the assistant's answer'
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Tuesday Telescope: Lighting, sprites, and airglow over Central America - Ars Technica
but this device (an Inductor) … impedes the rapid changes in the current.
so, what happens?
Here is a simplified AC power diagram.
As an inmate did you have to live alongside a bully for your whole sentence?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–10[John johnson John Johnson ]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
'King of the Hill' Reboot First Details: Hank, Peggy, Bobby, Dale - Variety
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then describes Rainy Season and Lightning.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Could Trump’s ‘big beautiful bill’ kill the OFR and accidentally sabotage SOFR? - Financial Times
Now when you have a certain ac resistance, then a current flows in a loop.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There are three different concepts here that are getting confused.
The MOV will conduct when the voltage exceeds 50% of line voltage.
At one ohm, the resistor has a maximum of 1 watt power.
But… the neutral is now “floating” because of the 1 ohm resistance.
One
There are two important concepts here.
but I think this circuit , shows a few more pieces.
(Dc diagram shown, AC is similar).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These are simplified answers to the original question, and does not change anything I wrote above.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
nine
eight
He then describes the function of a fuse.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This device then solves the entire problem.
What is lightning?
An AC voltage/ current source, and an ac inductive load.
This is where this question deviates from being a 'generic' question, and becomes more specific.
I post the exact comment here.
A circuit breaker is similar, but is resettable.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It seems Mohan does not understand the difference between a comment and an Answer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–16 [ OO OLAOYE OYEBODE ]
For this case there are devices called Metal oxide varistors (MOV).
One is “what exactly is in a ‘surge protector’ ? ”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The bolt then partially travels down the line to your home.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
First Sentence:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Edit 2024–10.